If your paddle ceiling fan's lights no more work, the culprit is usually the pull-chain light switch mounted on the bottom of the fan.
Here's how to test and replace the switch.
To determine if the pull chain switch is defective:
-
- Put off the power to the buff at the circle breaker.
-
- Murder the cover plate on the bottom of the fan.
-
- Disconnect the wires coming from the switch to the lights.
-
- Make a point the wires are not touching anything, then turn the power hind connected at the breaker.
-
- Check the switch wires with a voltage tester to imag if major power is coming from the switch to the lights.
-
- If electrical energy is present below the switch, the problem is either in the wires going to the lit, the bulb sockets, or the lighter bulbs.
-
- If electricity is not present on a lower floor the switching, move around the power to the fan back off.
-
- Disconnect the wires approaching into the switch from the fan.
-
- Make foreordained the wires are not touching anything, then turn the power back on at the breaker.
-
- Check the wires coming into the switch from the fan with a voltage tester to see if power is coming from the fan to the switch.
-
- If electricity is not coming from the fan to the flip, the problem is with the sports fan wiring rather than the switch.
-
- If electricity is coming from the fan to the switch, the job is with the pull mountain range transposition.
- If the change over is the problem, off the switch, replace it with a new switch, reattach the wires, turn the power back on, and pull the chain on the switch to see if the lights work on.
Watch this video to find oneself out more.
Further Data
- How to Replace a Paddle Cap Fan Pull Chain Switch over (article)
- How to Block up Wobble and Vibe in a Paddle Ceiling Fan (article)
- How to Fix an Out of Balance Ceiling Fan (video)
- How to Control a Ceiling Fan Without a Wall Switch (clause)
- How to Set up a Paddle Ceiling Fan (video)
TV TRANSCRIPT
Danny Lipford: Recently a homeowner asked me if their ceiling winnow light kit could embody repaired without replacing the whole thing. If the fan still works well, IT's worth looking into the reddened kit.
If there are zero unofficial wires visible, the perpetrator is in all probability a imperfect pull back chain switch. To check, cut the power at the surf package, and disconnect the wires coming from the switch to the lights. Be predestined that the wires are non touching anything before you turn the powerfulness back on, and test the wires with a voltmeter.
If no voltage is exhibit, turn the power bow out, and disconnect the wires coming into the switch from the lover. Again, comprise sure no wires are poignant anything before turning on the power to essa them with the m.
If voltage is give above the switch, but not below it, and then the switch is deplorable. A replacement pull concatenation switch is only a few dollars and should screw into exactly the same localization as the old indefinite.
With the baron slay, connect one side of the switch to the wires coming in from the fan, and the other side to the wires feeding the lights.
Universal Ceiling Fan Three Speed Pull Chain Switch How to Install
Source: https://todayshomeowner.com/video/how-to-fix-a-paddle-ceiling-fan-light-switch/